Size Surface

In the vents set within a fine mesh to protect from rodents. If you are unsure how to proceed, check out Robert J. Shiller. Wall. Frame the walls of bars or logs, hewn into four edge size 14X14 cm angles Pair of rims studs in poldereva. Bruce Schanzer: the source for more info. The lower and upper trim the same. In each of the rims of the frame mark out the place setting studs. Rack mounted on each corner house and on the sides of each door and window openings. Intermediate racks placed at a distance of 1,2-1,5 m. The length of legs is equal to the height of floors (2.5 m). To harness hollow nest the size of 2,5 X4, 5 cm, depth 4 cm, with both ends of the racks cut down spines, whose length should be less than the depth of the nest to see 0,3-0,5 Posts and railings frame set only to plumb and level. Level to check the rims of the frame is placed on two-meter line.

After full Build the frame and check that it is installed on the corners put the struts in two planes, and in places of door and window openings – crossbars. Outside frame sheathe nestroganym planks (no slack), with a smooth surface. Surface cover the roofing material from the bottom up, top panel overlaps the bottom of 10-15 cm over the entire surface of walls attached metal mesh with tension. Grid firmly nailed to the sheathing, otherwise the plaster may peel off from the wall surface. Sheathing boards split and left driven into the gap wedges. At the corners are stuffed boards 40 mm thick, covered with netting.